DMX Settings
The DMX Settings Window defines how DMX is output by the console for each universe. By
default, each console universe is output to the corresponding DMX port located on the
console’s rear panel.
•
Send Over Network:
Each DMX universe can be duplicated and output via the network
port. Select a universe tab, then select the protocol required from the "Send Over
Network" drop-down. Assign the Art-Net/sACN universe to transmit on.
•
Test Mode:
Turn this on temporarily to send a ramp output on all 512 DMX channels to
test your connection to your lighting. Fixtures do not need to be patched.
•
Allow other consoles to control this universe.
This is typically only used on a QuickQ
Rack. When selected, the QuickQ Rack will hand over control to the other console when it
detects another console’s output on the network’s universe. The QuickQ Rack will control
lighting until the stage lighting console is turned on and will have control automatically
once the stage lighting console is turned off.
Setting Up a QuickQ Console to Output Art-Net
First, the console IP Address must be set. From the Home menu on the console, go to Settings,
Network, Wired.
Double-tap to set the IP address to the required IP schemes Note:it is recommended that Art-
Net run on a 10.x.x.x or a 2.x.x.x IP scheme.
46
QuickQ v6
2021-03-12
