17
100472 - 3 iN. (7.6 cM) chiPPER ShREDDER
ASSEMbLY
NOTicE
Once oil has been added, a visual check should show oil about
1-2 threads from running out of the fill hole.
If using the dipstick to check oil level, DO NOT screw in the
dipstick while checking.
NOTicE
Check oil often during the break-in period. Refer to the
Maintenance section for recommended service intervals.
cAUTiON
The engine is equipped with a low oil shut-off and will stop
when the oil level in the crankcase falls below the threshold
level.
NOTicE
We consider the first 5 hours of run time to be the break-
in period for the engine. During the break in period we
recommend using standard automotive non-synthetic blended
oils. After the break in period synthetic lubricant can be used
but is not required. Avoid bogging or lugging the engine down
and avoid prolonged running at constant RPM. After the 5 hour
break-in period, change the oil.
NOTicE
Synthetic oil may be used after the 5 hour initial break-
in period. Using synthetic oil does not decrease the
recommended oil change interval. Full synthetic 5W-30 oil will
aid in starting in cold ambient < 41º F (5º C).
-20
0
20
40
60
Ambient temperature
Recommended Engine Oil Type
80
100
120
-28.9
°F
°C
-17.8 -6.7 4.4
15.6 26.7 37.8
48.9
10W-30
5W-30 Synthetic
10W-40
5W-30
NOTicE
Weather will affect engine oil and engine performance. Change
the type of engine oil used based on weather conditions to suit
the engine needs.
Add fuel
1. Use clean, fresh, regular unleaded gasoline with a minimum
octane rating of 87 and an ethanol content of less than 10%
by volume.
y b c
2. DO NOT mix oil with gasoline.
3. Remove the gasoline cap.
4. Slowly add gasoline to the tank. DO NOT OVERFILL.
A minimum of ¼ in. (6.4 mm) of space left in the tank is
required for gasoline expansion, although more than ¼ in.
(6.4 mm) is recommended. If overfilled, gasoline can be
forced out of the fuel tank as a result of expansion and can
affect the stable running condition of the chipper-shredder.
5. Screw on the gasoline cap and wipe away any spilled fuel.
cAUTiON
Use regular unleaded gasoline with a minimum octane rating
of 87 and an ethanol content of less than 10% by volume.
DO NOT light cigarettes or smoke when filling the tank.
DO NOT mix oil and gasoline.
DO NOT overfill the fuel tank. Always fill the fuel tank to
approximately ¼ in. (6.4 mm) below the top of the tank to
allow for gasoline expansion.
DO NOT pump gasoline directly into the chipper-shredder at
the pump. Use an approved container to transfer the gasoline
to the chipper-shredder.
DO NOT fill fuel tank indoors.
DO NOT fill tank when the engine is running or hot.
WARNiNG
Pouring gasoline too fast through the fuel screen may result in
blow back of gasoline at the operator while filling.
