Model
Number:
SLY2500
SLY2500E2
Controller
none
CB400
Max. Gate weight
(kg)
2500kg
2500kg
Motor
Protection
Switch
yes
yes
Hold to run function
no
yes
Automatic
function
no
yes
IR-Sensor
no
yes
Automatic close
no
yes*
Flashing
Light
no
yes*
Safety
edges
no
yes*
Emergency
Stop no
yes*
Radio
no
external
External Light switching function
no
yes*
Traffic light with Red-Light
no
yes*
* requires optional ZM-SKS-B plug in card
Technical Data
Voltage
230V
Phases
1
Frequency
50Hz
Capacitor
2
x
16µF
Current
(nominal)
3,85A
Power
0,55
kW
Torque
(max.)
120Nm
Gear
Reduction
1:40
Duty Cycle Rating
50%
Temperature
Range
-25/+55°C
Thermal
Protection:
140°C
IP-Rating
IP55
Gate
Speed
10m/min
Sprocket 90mm
/
Module
4
Weight
41kg
INSTALLATION OF DRIVE
The base for the drive can either be concreted or, if
appropriate, made of steel.
The concrete plinth needs to be of an appropriate size
(approx. 80cm long x 80cm wide x 100cm deep).
Notice:
Precisely determine the height of the plinth
(motor mounting socket) and the distance from the gate
prior to installation. You are advised to work as
precisely as possible.
MOUNTING MOTOR AND GEAR UNIT
The weight of the gate should not be borne by the cog
wheel! Position the drive via the adjustment holes such
that its location vis-à-vis the rack bar complies with the
installation dimensions.
MOUNTING RACK BAR
The easiest way to fit the rack bar is to first place it on
the motor's drive cog, disengage the motor and, by
pushing the gate further with the rack bar, screwing the
bar bit by bit firmly in position. In this way, you ensure
that the rail bar engages with the cog wheel in an
optimum manner. While doing this, do not forget to
mark each fixing point.
Notice:
Steel racks are recommended (320001 = 1m)
For gates with weights above 3.000kg it is recommended to
use two steel racks.
The tooth racks should be fitted as shown with an overlap
from rack to rack. For two rack mounting the M8 screw must
be replaced with a longer type to suit the application.
