CHAINTECH CT-6BPV, Руководство пользователя

Страница: 15 / 56

Hardware Setup
11
2-4 Connector and Jumper Settings
Connectors are used to link the system board with other parts of the system, including
the power supply, the keyboard, and the various controllers on the front panel of
the system case.
The power supply connector is the last connection to be made while
installing a mainboard. Before connecting the power supply, please make
sure it is not connected to the power source.
ATX Power Supply Connector (CN3 riser card)
This mainboard requires a power supply of at least 135
watts. The power cord leading from the system's power
supply to the external power source must be the very
last part connected when assembling a system.
The ATX power supply provides a single 20-pin connector
interface which incorporates st/-5V, +/-12V,
optional 3.3V and Soft-power signals. The Soft-power
signal, a 5V trickle supply is continuously supplied when
AC power is available. When the system is in the Soft-
Off mode, this trickle supply maintains the system in it's
minimum power state.
Software Power-Off Control
This mainboard can be powered down using theWindows 95 Software Power-Off
function. To power down your computer, click the START button on the Windows 95
Task Bar. Select "Shut Down The Computer" and the system turns off. The message
"It is now safe to turn off your computer" will not be shown when using this function.
Power-On By Modem Power-On By Modem Power-On By Modem Power-On By Modem Power-On By Modem
While in Soft-off state, if an external modem ring-up signal occurs, the system wakes
up and can be remotely accessed. Enable this function in BIOS's Power Management
Setup menu. (See section 3-4)