EN
0. Introduction
Thank you for using this product.
- Please read all instructions carefully before using the product.
- Don’t attempt to disassemble or repair the product yourself, as this will invalidate the warranty.
1.1. Battery installation: Central alarm unit with motion detector
1. Using a crosshead screwdriver, remove the screw from the back of the motion detector.
2. Slide the cover down to access the battery compartment.
3. Insert the batteries, ensuring correct polarity (+/-).
4. Close the compartment with the cover and screw.
Note:
When the battery is low, the LED indicator will flash slowly (3s/flash)
1.2. Battery installation: remote control
1. Using a crosshead screwdriver, remove the screw on the back of the
remote control.
2. Slide the cover to the left to access the battery compartment.
3. Insert the battery, making sure that the polarity is correct (+/-)
4. Close the compartment with the cover and screw.
1.3. Battery Installation: Door Opening Sensor
1. Using a crosshead screwdriver, remove the screw on the front of the
opening detector
2. Slide the cover down to access the battery compartment.
3. Insert the battery, ensuring correct polarity (+/-)
4. Close the compartment with the cover and screw.
2. Synchronisation of devices
1. Using a screwdriver, open the battery compartment of the main unit.
2. Press and hold the learn button until you hear a «beep». The unit enters pairing mode.
3. Separate the two parts of the opening detector to send a signal to the main unit. You will hear a «beep» sound to
indicate that the pairing was successful.
4. Press any button on the remote control. You will hear a «beep» sound to indicate successful pairing.
5. To exit pairing mode, press and hold the learn button for 3 seconds. You will then hear a double «beep».
NOTE:
A maximum of 32 transmitters can be paired to a main unit.
Содержание 34035
Страница 31: ......
Страница 32: ...Chacon S A Avenue Mercator 2 1300 Wavre Belgium Made in PRC v1 210809...