CH Hanson NORSE 9683412, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 32

ELECTRICAL
All electrical connections must be
performed by a qualified electrician.
Power Source
Connect sander to a supply circuit protected by a circuit breaker or time-delay fuse.
The motor is designed for operation on the voltage and frequency specified. Normal loads will
be handled safely on voltages not more than 10% above or below the specified voltage.
Running the unit on voltages which are not within the range may cause overheating and motor
burn-out. Heavy loads require that the voltage at motor terminals be no less than the voltage
specified. Power supply to the motor is controlled by a single pole locking rocker switch.
Remove the key to prevent unauthorized use.
Grounding Instructions
Improper connection of equipment grounding conductor can result
in the risk of electrical shock. Equipment should be grounded
while in use to protect operator from electrical shock.
Check with a qualified electrician if grounding instructions are not understood or if in doubt as to
whether the tool is properly grounded.
This tool is equipped with an approved 3-conductor cord rated at 300V and a 3-prong
grounding type plug for your protection against shock hazards.
Grounding plug should be plugged directly
into a properly installed and grounded 3-
prong grounding-type receptacle, as shown.
Do not remove or alter grounding prong in
any manner. In the event of a malfunction or
breakdown, grounding provides a path of
least resistance for electrical shock.
Do not permit fingers to touch the terminals of plug when installing
or removing from outlet.
Plug must be plugged into matching outlet that is properly installed and grounded in
accordance with all local codes and ordinances. Do not modify plug provided. If it will not fit in
outlet, have proper outlet installed by a qualified electrician.
Inspect tool cords periodically, and if damaged, have repaired by an authorized service facility.
Green (or green and yellow) conductor in cord is the grounding wire. If repair or replacement of
the electric cord or plug is necessary, do not connect the green (or green and yellow) wire to a
live terminal.
Where a 2-prong wall receptacle is encountered, it must be replaced with a properly grounded
3-prong receptacle installed in accordance with National Electric Code and local codes and
ordinances.
3-Prong receptacle.
Properly Grounded Outlet
Grounding Prong
3-Prong Plug
6