CH Hanson NORSE 9683412, Инструкция по эксплуатации и каталог запасных частей

Страница: 26 / 32

TO SET THE BLADE AT 0° AND 45°
See Figures 46 - 48.
The angle settings of the saw have been
set at the factory and, unless damaged in
shipping, should not require setting during
assembly. After extensive use, they may
need to be checked.
•
Unplug the saw.
• Raise the blade.
• Remove the blade guard assembly.
If the blade is not perfectly vertical (0°):
• Loosen the adjustment screw and the
bevel locking knob.
Fig. 48
45°
COMBINATION
SQUARE
BLADE
BEVEL
HANDLE
BEVEL
INDICATOR
BEVEL
LOCKING
KNOB
Fig. 47
0° ADJUSTMENT
SCREW
0° ADJUSTMENT
SCREW
45° ADJUSTMENT
SCREW
45° ADJUSTMENT
SCREW
COMBINATION
SQUARE
BLADE
BEVEL
INDICATOR
BEVEL
LOCKING
KNOB
0°
0° ADJUSTMENT
SCREW
45° ADJUSTMENT
SCREW
• Place a combination square beside the
blade on the left.
• Lock the angle by pushing the bevel
locking lever down and retighten the
adjustment screw.
• Turn the handle until the bevel indicator
points to zero. If the handle is turned as
far as possible and doesn’t indicate zero
properly, you may need to adjust the
bevel indicator.
NOTE:
handle to adjust the bevel indicator.
If the blade is not an exact 45°:
• Loosen the adjustment screw and the
bevel locking knob.
• Place a combination square beside the
blade on the left.
• Turn the handle until the bottom of the
blade has moved completely to the left side of the slot. Lock the angle by pushing the
bevel locking lever.
• If the blade is not an exact 45°, loosen the 45° adjustment screw and the bevel
locking lever.
• Adjust the bevel indicator to 45°.
• Make a test cut.
26
BLADE ADJUSTMENTS