Cetrek PROPILOT 700, Руководство по установке и обслуживанию

Страница: 11 / 40

-11-
PROPILOT 700 INSTALLATION & SERVICING MANUAL
807-007-5-96
The heavy duty supply should be fused according to the
drive unit fitted:
930 403, 404, 415 30A Antisurge
930 413, 414 20A Antisurge
Hydraulic Drive units connect into existing manually
operated hydraulic steering systems. Hydraulic pumps
should be mounted on a rigid base to avoid unnecessary
vibration and noise.
The heavy duty supply should be fused according to the
drive unit fitted:
930 100,101,130,132,135,160,161,162 30A Antisurge
930 110,111,155,170,171,172,180,182 20A Antisurge
930 146 10A Antisurge
930 102,112 (Continuous Running Pumps) 5A Antisurge
For other continuously running pumps use a fuse rating of
a suitable size for the solenoids.
For either system it is acceptable to use a Fused switch or a
Circuit breaker. Changing the Phasing to reverse the
rotation of the motor is explained later in the Installation
Settings.
Good Wiring Having decided on the location and position of each unit it
Practice is essential to check the cable runs to ensure that there are
no problems.
All cable runs should be kept as clear as possible from other
cables carrying RF (radio frequency), pulsed signals or heavy
currents (such as winches etc.). At least 3 ft. clearance is
advised. Take particular care to ensure the maximum
clearance from radio transmitting aerials.
If it is necessary to extend any of the cables, the same type
of cable must be used and the screens must be connected.
Screened cables should be earthed at the Distribution Box
using the clamping bars provided.
If it is necessary to extend the Drive Unit cables, they should
be extended using a heavy duty cable, by the shortest
possible route, to avoid unnecessary power loss.
Installing Your Propilot 700