Cetrek PROPILOT 700, Руководство по установке и обслуживанию

Страница: 7 / 40

-7-
PROPILOT 700 INSTALLATION & SERVICING MANUAL
807-007-5-96
INSTALLING YOUR PROPILOT 725
Before you Before commencing the installation of your new pilot please
Start carry out the following initial checks:
• that the correct items have been delivered ?
• that the units are undamaged ?
• that the correct voltage drive unit has been supplied ?
• if using a Mechanical Drive Unit, that the correct chain and
sprocket is available ?
• if you are using a hydraulic pump, that you have the correct
size fittings available to connect the pump ?
• that you have the correct type of hydraulic fluid to top up the
steering system once the pump is installed ?
• that you have a power cable of a suitable gauge to supply
power to the system?
• that you have a Circuit Breaker of suitable size for your
system? A Light Duty Switch is required near the Propilot 700.
If you find an error please contact the supplier of the
product immediately.
Before the drilling or cutting of any holes takes place, please
consider the exact location and cable routing that is
required for each unit. Please read this installation section
and any installation information supplied with your units
before you install the system.
Caution! All exposed moving parts must be sufficiently guarded to
prevent accidential damage to persons or clothing.
Suggested We suggest that the following procedure will allow you to
Procedure install the system encountering the least problems.
• Read this section then select the best positions for the units.
• Install the Distribution Box.
• Install the Autopilot Control and route the cable to the
Distribution Box.
• Install the Compass Sensor and route the cable to the
Distribution Box.
• Install the Rudder Feedback Unit and route the cable to the
Distribution Box.
• Install the drive unit. Route the cable to the Distribution Box.
• Route the light and heavy duty power supplies to the
Distribution Box.
Installing Your Propilot 700