52"
28"
59"
Step 6
Attach another Arbor Post over the opposite side. Start from one end of the pannel and work to another.
Slide two (2) 4" Knuckles on the short ends of each of the Arbor Posts.
Repeat this step to create another Arbor side.
Step 7
Dig four (4) holes approximately 10" round and
12" deep. The holes should be spaced apart as
shown in the diagram above.
Step 8
Place the assembled Side Panels into the holes. The
bottom edge of the lower Cross Member should be
13" from the ground with drain holes exposed.
Step 9
Install the Arch onto the top of the Arbor Posts
as shown above. (If desired, PVC glue can be
added to the inside of the Arbor Posts prior to
attaching the Arch.
Step 10
Fill the four holes with cement. Frequently
check that the finished Arbor is level in all directions.
13"
Drain Hole
