Step 1
Step 3
Repeat this process for the second arch. They
should look as shown above.
Lay one (1) Arbor Post onto a clean soft surface and slide the Lattice Panel into the long slot starting at
one end until it is completely in place. Insert two (2) 1 1/2" x 1 1/2" Cross Members (with notches) into the
square holes at the top and bottom of the Arbor Post. Make sure that the non-notched side faces
the lattice.
Step 4
Step 2
Assembly Instructions
Step 5
Notch
Notch
Slide one of the Male/Male Arch sections into a
Female/Male section until they are flush.
Align the pegs on the keystone with the
four mating holes on the arch. Push until it is
flush with the arch. Slide on another Keystone half
onto the arch and snap both halves together.
Insert (8) 1 1/2" x 1 1/2" Cross Members without
notches into one of the assembled Arches.
Place the second Arch assembly against the
opposite end of the Cross Members and install
them one at a time until both Arch halves are fully
together.
