3.
Make certain that the area in which you are cutting is free from obstructions. Do not let the
nose of the guide bar contact a log, branch, or any other obstruction which could be hit while
you are operating the saw.
4.
Cut at high engine speeds.
5.
Do not overreach or cut above shoulder height.
6.
Follow sharpening and maintenance instructions for saw chain.
7.
Only use replacement bars and chains specified by Kogan.com customer support.
Maintenance
•
In order to maintain your product in proper working order, perform the maintenance and checking
operations described in the manual at regular intervals.
•
Always be sure to turn off the engine before performing any maintenance or checking procedures.
The metallic parts reach high temperatures immediately after stopping the engine.
Transportation
•
Always carry the unit with the engine stopped, the guide bar covered with the protector to the rear
and the muffler away from your body.
Installing Guide Bar and Saw Chain
A standard saw unit package contains the items as illustrated.
(1) Power unit
(2) Bar protector
(3) Guide bar
(4) Chainsaw
(5) Plug wrench
(6) Screwdriver for carburettor adjustment
(7) Spike and mounting screws
Open the box and install the guide bar and the saw chain on the power unit as follows:
The saw chain has very sharp edges. Use thick protective gloves for safety.
1.
Pull the guard towards the front handle to check that the chain brake is not on.
2.
loosen the nuts and remove the chain cover.
3.
Install the attached spike to the power unit.
4.
Gear the chain to the sprocket and, while fitting the saw chain
around the guide bar, mount the guide bar to the power unit. Adjust
the position of chain tensioner nut on the chain cover to the lower
hole of guide bar.
(8) Hole
(9) Tensioner nut
(10)Chain cover
Pay attention to the correct direction of the saw chain.
5.
Fit the chain cover to the power unit and fasten the nuts to finger tightness.
6.
While holding up the tip of the bar,adjust the chain tension by turning the tensioner screw until
the tie straps just touch the bottom side of the bar rail.
7.
Tighten the nuts securely with the bar tip held up (1 2-1 5 N. m) .Then check the chain for smooth
rotation and proper tension while moving it by hand. If necessary, readjust with the chain cover
loose.
8.
Tighten the tensioner screw.
A new chain will expand its length is the beginning of use. Check and readjust the tension
frequently as a loose chain can easily derail or cause rapid wear of itself and the guide bar.
5
Содержание CTCHNSAW52A
Страница 1: ......
