
fghj
12
CBX
Timer
Timer
On/Off, switch the timer function on or off
Interval min
Delay time between samples in minutes
Relay
Relay 1/ Relay 2, can be used as level alarms. You
can configure one of the internal relays as a timer
to start the CBX if you do not have a rake to use as
a trigger.
Next time
Next time the sample starts
Information display
If you press
ê
and ENT key at the same time you will see an information display that
shows the status of the display.
If you press one more time at the
ê
and ENT key you will see a graphical profile of the
last sampling (available on software on the BB1/BB2 3.23 and later) .
The profile shows fluff and sludge level, the top number is fluff level and the lower
number is sludge level measured from the tank bottom and up.
fig 3
Profile
CBX users can get the sludge profile using the 4 output signals on the BB2. It is updated
at the end of each sampling cycle (channel 3 & 4 are on-‐line during sampling). This
option requires an extra card in theBB2 unit with two more 4-‐20mA signals (total 4
outputs). For to have a good resolution on the profile, sample CH1 and CH2 with 1 Hz.
Attach the extra mA card to the BB2 (P/N 11905782) see appendix 6.
Follow the checklist below to get started
-
Set the analog outputs on the BB2 to “all” (settings/analog)
-
Set second to “fluff” (settings/second)