Ceragon FA4800, Руководство пользователя

Страница: 60 / 333

Connecting power to the IDU Chapter 3
FA4800 User Manual Release 1.9.30 3-13
Connecting power to the IDU
The IDU-C has redundant power connection circuits (items G and H in
Figure 3-12 above). An enlarged schematic of the power connectors is
shown in below:
Figure 3-16: IDU-C Power connectors
The connectors are 3 pin in line female, with polarities (left to right) minus,
ground, plus. To avoid damage to the IDU, always use an AC/DC adapter
supplied by Ceragon.
Ensure that the IDUs at both sites are powered up.
The IDU-E has a single three pin power connector, the same as used on the
IDU-C.
The IDU-R models have a two pin power connector and an AC/DC adapter
supplied by Ceragon.
Connecting the ODU to the IDU
The ODU-IDU cable conducts all the user traffic between the IDU and the
ODU, and also provides power to the ODU. The maximum length of the
ODU-IDU cable is 100m (328ft) in accordance with 10/100BaseT standards.
The ODU-IDU cable is supplied pre-assembled with RJ-45 connectors, at the
length specified when ordering, or as a cable drum with spare connectors. If
the ODU-IDU cable was not ordered, use an outdoor class, CAT-5e 24AWG
shielded cable. See
Appendix B for Wiring Specifications.
To connect the ODU to the IDU, route the cable from the ODU to the IDU,
secure the cable along its path and connect the cable to the ODU RJ-45
connector on the IDU (see item B in
Figure 3-12 above).
Installing a Link using PoE Devices
The PoE device is a very simple unit having a power input connector and
two Ethernet ports. It is AC powered, and has a power LED.
¾
To prepare a link using PoE devices:
1. To connect the ODU to the PoE device, route the cable from the ODU to
the PoE device, secure the cable along its path and connect the cable to
the LAN-OUT RJ-45 connector on the PoE device.
2. Connect it to AC power.