Page 7
SKU 39092
For technical questions, please call 1-800-444-3353.
Loading Brads
ALWAYS WEAR ANSI APPROVED IMPACT SAFETY GOGGLES WHEN
RELOADING OR DOING ANY OTHER MAINTENANCE ON THIS TOOL.
Other people in the work area must also wear ANSI approved impact safety
goggles.
Warning! Make sure the Nailer is not attached to the air hose whenever loading
the tool.
1.
Push the Latch Grip (6453) forward and slide open the Magazine (6465). Pull
the Nail Pushing Plate (6468) back until the Latch Grip is engaged.
2.
Load the Brads by holding the Nailer with its Magazine (6465) tilted slightly down-
ward.
3.
Close the Magazine (6465). Slide the Magazine gently forward. Do not force the
Magazine or the Brads, as this may result in a jam. Make sure the Latch Grip
(6453) catches after closing the Magazine.
MAGAZINE
(6465)
LATCH GRIP
(6453)
NAIL PUSHING PLATE
(6468)
stop immediately and have it repaired by a qualified service technician.
7.
Hold the tool away or off of the workpiece. The Safety Frame (6459) of the tool
should return to its original position. Squeeze the Trigger (6435).
The tool
should not cycle (fire).
If the tool fires, stop immediately and have it repaired by
a qualified service technician.
8.
Depress the Safety Frame (6459) against the workpiece and squeeze the Trigger
(6435).
The tool must cycle (fire).
Release the Trigger and squeeze it again.
The tool must cycle (fire).
With the Trigger held, carefully lift the Nailer and
press it against the workpiece again.
The tool must cycle (fire).
If it fails to
perform in the manner explained in bold, have it repaired by a qualified service
technician.
