12.
REMOVE ADJUSTING KEYS AND WRENCHES.
Make it a habit to check that keys and
adjusting wrenches are removed from the tool or machine work surface before plugging it in.
13.
AVOID UNINTENTIONAL STARTING.
Do not carry any tool with your finger on the trigger,
whether it is connected to the compressor or not.
14.
STAY ALERT.
Watch what you are doing; use common sense. Do not operate any tool when
you are tired.
15.
CHECK DAMAGED PARTS.
Before using any tool, any part that appears damaged should
be carefully checked to determine that it will operate properly and perform its intended func-
tion. Check for alignment and binding of moving parts; any broken parts or mounting fixtures;
and any other condition that may affect proper operation. Any part that is damaged should be
properly repaired or replaced by a qualified technician. Do not use the tool if any switch does
not turn on and off properly.
16.
REPLACEMENT PARTS AND ACCESSORIES.
When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool. Approved accessories are available from Harbor Freight Tools.
17.
DO NOT OPERATE TOOL IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
Read warning labels on prescriptions to determine if your judgment or reflexes are impaired
while taking drugs. If there is any doubt, do not operate the tool.
18.
DRAIN COMPRESSOR EVERY DAY.
Do not allow moisture to build up inside the
compressor. Do not allow compressor to sit pressurized for longer than one hour.
19.
MAKE SURE ALL EQUIPMENT IS RATED TO THE APPROPRIATE CAPACITY.
Make
sure that regulator is set at least 10 PSI lower than the lowest rated piece of equipment you
are using.
UNPACKING
When unpacking your 5" Sander/Drill, check the items against the list below. If any parts are
missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Item#
Description
Qty
N/A
Drill Assembly
1
26
Holding Tool
1
N/A
Chuck Key
1
30
5-1/2" Backing Plate
1
29
4-1/2" Backing Plate
1
28
3" Backing Plate
1
27
Adapter Lock Down
1
ASSEMBLY
Your Sander/Drill comes assembled and ready for use as a Drill. To convert your Sander/Drill
for use as a Sander, follow the Steps below.
Sander Assembly
Step 1: Open the CHUCK (#31) by turning the CHUCK counterclockwise. Insert the short end of
a Hex Key Wrench into the CHUCK and tighten.
REV 01/04
Page #3 -- SKU: 35245
WARNING:
This product contains or, when used, produces a chemical known to the State of
California to cause cancer and birth defects or other reproductive harm. (California Health &
Safety Code 25249.5, et seq.)
Содержание 35245
Страница 11: ...Page 11 SKU 35245 ASSEMBLY DIAGRAM...