Central Pneumatic 35245, Руководство по сборке и эксплуатации

Страница: 7 / 11

The connector on the tool must not hold pressure when the air supply is disconnected. If the
wrong fitting is used, the tool can remain charged with air after being disconnected and still be
able to drive a fastener. See Figure 4 for the recommended accessories and connection order.
Figure 4 — Airline Oiler Assembly
Use
Step 1: Set the compressor’s pressure regulator to 90 PSI. Do not set the compressor’s outlet
regulator over 90 PSI.
Step 2: Connect the Sander/Drill to the air compressor’s hose. If leaking is detected,
disconnect the air hose and repair before use.
Drilling
Step 1: Mark the material you wish to drill at the spot for the hole. Make sure your drill bit is the
correct size for the hole you need to make.
Step 2: If possible, clamp the material in a vise to make sure the material does not move or
begin to spin while drilling.
Step 3: Wear eye protection to guard against flying wood or metal.
Step 4: Set the compressor’s pressure regulator to 90 PSI. Do not set the compressor’s outlet
regulator over 90 PSI.
Step 5: Connect the Sander/Drill to the air compressor’s hose. If leaking is detected,
disconnect the air hose and repair before use.
Step 6: Grip the Sander/Drill firmly. Place the drill bit on the spot marked in Step 1.
CAUTION
Do not operate the Drill
before placing the drill bit
on the material.
Page #7 -- SKU: 35245
Figure 4 -- Airline Oiler Assembly