Page 10
SKU 95906
For technical questions, please call 1-800-444-3353.
With the Drum (55) operating between 20 to 36 RPM, the Mortar Mixer is now ready
for the addition of the concrete mix.
To determine the proper amount of water, gravel, cement, and sand, refer to the
following Table.
(see Figure E.)
For best results, proceed as follows:
Pour the required amount of water into the Drum (55).
Add the required amount of gravel into the Drum (55).
Add the required amount of cement into the Drum (55).
Add the required amount of sand into the Drum (55).
(see Figure E.)
Allow adequate time for the water, gravel, cement, and sand to thoroughly mix.
To discharge the cement mix, release the Drum Lock (72). Raise the Drum Latch
(20) up, and pull the Dump Handle (60) down.
(see Figure d.)
After discharging the cement mix, raise the Dump Handle (60) to return the Drum
(55) to its original position. Lower the Drum Latch (20). Reset the Drum Lock (72).
Then turn the Clutch Lever (19) to the left to stop the Drum (55) from rotating.
(see Figure d.)
When finished, turn off the Engine of the Mortar Mixer and allow the unit to com-
pletely cool. Then, make sure to thoroughly clean the inside of the Drum (55) and
exterior of the Mortar Mixer (see cleaning instructions on next page.)
Always store the Mortar Mixer in a clean, dry, safe location out of reach of children
and other unauthorized people.
InsPECTIOn, MAInTEnAnCE, And ClEAnIng
wARnIng!
Never perform any services or maintenance on the Mortar Mixer
while it is running. Before performing any inspection, maintenance, and cleaning,
turn off the Engine and disconnect the Spark Plug Wire from the Spark Plug to
prevent accidental starting. Then, allow the Engine to completely cool.
5.
6.
7.
•
•
•
•
8.
9.
10.
11.
12.
1.
FIgURE E
