Page 18
SKU 95112
for technical questions, please call 1-800-444-3353.
The height of the Spreader (6B) should be adjusted so that the Clear Blade
Guard (2B) contacts the Saw Table (8E).
When finished, retighten the 8mm Washer (43E) and 8mm Hex Head Bolt (44E)
on the front mounting slot of the Spreader (6B).
(see assy. diagrams b and e.)
to adjust the Miter gauge:
The Miter Gauge (4A) features adjustable index stops at 90 degrees and 45 de-
grees, right and left. Adjustments to the index stops can be made by loosening the
Locking Nut (12A) and tightening or loosening the three Round Head Screws (5A).
Make sure to retighten the Locking Nut after the adjustment is made.
(see assy. diagram a.)
To operate the Miter Gauge (4A), loosen the Handle (1A) and move the Miter Gauge
Head to the desired angle. The miter gauge Head will stop at 90 degrees and 45
degrees, right and left. To position the Miter Gauge Head past these points, push
down the Miter Gauge Stop (7A). Position the Miter Gauge Head at the desired
angle and retighten the Handle (1A).
(see assy. diagram.)
to connect to the dust port:
The Base (9E) of the Table Saw features a Dust Port to which you can connect a
vacuum hose (not included) to collect the sawdust.
(see figure i.)
figure i
base
(9e)
dust port
To connect to the Dust Port, insert a hose clamp (not included) over the end of
the vacuum hose. Insert the end of the vacuum hose onto the Dust Port. Then,
secure the vacuum hose to the Dust Port by tightening the hose clamp.
note:
The vacuum hose must have an
inside diameter of 4”
to properly fit onto the Dust
Port.
(see figure i.)
b.
c.
1.
2.
1.
2.