Page 16
SKU 95112
for technical questions, please call 1-800-444-3353.
Move the framing square to the back and measure the length from the other end of
the Fence Bracket Body (9C).
(see figure g.)
If the distances are different, adjust one of two Plastic Screws (30C) located on the
top/front of the Fence Bracket Body (9C) until the distances from the front and rear
of the Fence Bracket Body to the Miter Gauge groove. Then, lower the Lock Knob
(18C) to lock the Rip Fence in place.
(see figure g.)
to install the blade guard assembly:
warning!
Make sure the Power Switch (17E) is off and the Table Saw is unplugged
from its electrical outlet. Failure to do so could result in accidental starting, causing
serious injury.
(see figure f.)
clear blade guard (2b)
rear
spreader
support
(40e)
guard support rod
(37e)
spreader
(6b)
8MM HeX bolt (44e)
8MM wasHer (43e)
8MM HeX bolt (50e)
8MM locK wasHer (51e)
spreader
(6b)
figure H
Insert the threaded portion of the Guard Support Rod (37E) through the hole in
the Rear Trunnion Bracket (77D). Then secure the Guard Support Rod, using one
12mm Lock Washer (54D) and one 12mm Hex Nut (55D).
(see figure H.)
Align the rear mounting hole of the Spreader (6B) with the threaded mounting hole
of the Upper Rear Spreader Support (40E). Secure the rear of the Spreader in
place, using one 8mm Washer (43E) and one 8mm Hex Head Bolt (44E).
(see figure H.)
Align the front mounting slot of the Spreader (6B) with the threaded mounting hole
of the Rear Trunnion Bracket (58D). Secure the front of the Spreader in place, using
one 8mm Hex Bolt (50E) and one 8mm Hex Nut (51E).
(see figure H.)
5.
6.
1.
2.
3.
4.