Page 15
SKU 95112
for technical questions, please call 1-800-444-3353.
Remove the scrap wood, and rotate the Saw Blade (86D) by hand to make sure it
turns freely.
(see figure f.)
Lower the Saw Blade (86D) and slip the Blade Insert (6E) into the opening in the
Saw Table (8E). Check to make sure the Blade Insert is flush with the Saw Table.
Do not allow the Blade Insert to bow up above the Saw Table surface.
(see figure f.)
to check rip fence and saw blade alignment:
warning!
Make sure the Power Switch (17E) is off and the Table Saw is unplugged
from its electrical outlet. Failure to do so could result in accidental starting, causing
serious injury.
warning!
Failure to align the Rip Fence to the Saw Blade (86D) can cause jams
and kickback, resulting in personal injury.
Miter gauge grooVe
Miter gauge grooVe
saw blade
(86d)
saw
blade
(86d)
plastic
screw
(31c)
plastic
screw
(31c)
Miter gauge
grooVe
fraMing sQuare
fence
bracKet
body
(9c)
fence
bracKet
body (9c)
locK Knob
(18c)
figure g
Unlock the Rip Fence by raising its Lock Knob (18C). Then slide the Rip Fence to
the Miter Gauge groove, which is parallel to the Saw Blade (86D).
(see figure g.)
Place a framing square (not included) against the Saw Blade (86D), with the long
end under the Fence Bracket Body (9C) at the front. Then, note the distance.
(see figure g.)
9.
10.
1.
2.
3.
4.