Page 9
SKU 67690
For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Electrical
Requirements
120 V~ / 60 Hz / 1.8 A
Maximum Stock
Length/Diameter 40” Long, 14” Diameter
Lathe Type
Wood Cutting Turning
Motor
1/2 HP @ 1800 RPM
Operating
Speeds (4)
930 RPM
1500 RPM
2050 RPM
2500 RPM
Swing Over Bed 13-13/16”
Tail Stock
Quill Travel
3-1/8”
Tool Rest Width 11-7/8”
Drive Method
Belt & Pulley
Belt Type
Rubber V-type 8-510
Worktable
7-3/8” W x 4-7/8” Deep
Power Cord
(E21210 & 215550)
1 PAWG/3C 105°C STT
Accessories
Miter Gauge (Qty. 1)
Spanner Wrench (27mm) (Qty. 1)
Sanding Disc
(Qty 3, 60, 80 and 100 grit)
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
ASSEMBLY INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch (14) of
the Lathe to its “OFF”
position and unplug the tool
from its electrical outlet
before assembling or making
any adjustments.
Note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
NOTE:
This Lathe requires partial
assembly.
1. To attach the Faceplate (9) to the
Main Spindle (2), loosen the Drive
Center (8) and remove it from the
Spindle. Do this by using the Spanner
(70) to hold Main Spindle in place.
Then use a wrench (not included) to
loosen and remove the Drive Center.
See Figure 1, below.
Figure 1
Spanner (70)
Drive
Center
(8)
Main
Spindle
(2)
