Page 13
SKU 67690
For technical questions, please call 1-800-444-3353.
To Adjust The Tail Stock:
1. Use the Spanner to loosen the Lock
Screw (19) under the Tail Stock (24).
Then slide Tail Stock to the desired
position. See Figure 11, below.
2. Use Spanner to tighten Lock Screw,
securing Tail Stock in place.
To Adjust The Tool Rest:
1. Use the Spanner to loosen the Lock
Screw (19) under Tool Rest Holder
(20). Slide Tool Rest Holder to desired
position. See Figure 12, below.
2. Use Spanner to tighten Lock Screw,
securing Tool Rest Holder in place.
4. Move the Drive Belt to the proper
grooves on the Drive Pulley (10) and
Motor Pulley (12). Make sure that
1/2” of Drive Belt deflection is mea-
sured, as shown in Figure 9 below.
5.
FIGURE 9
DRIVE
PULLEY
(10)
MOTOR
PULLEY
(12)
1/2”
DEFLECTION
DRIVE
BELT
(11)
Replace the Belt Cover, snap the
latch on, and use the Screws to se-
cure the Cover back into place.
6. Refer to the Recommended Turning
Speeds Chart below during use. See
Figure 10.
FIGURE 10
Recommended Turning Speeds
Max Work
Diameter In Inches
Speeds (RPM)
2”
2200~3200
3”
1600~2200
4”
1100~1600
5”
750~1100
6”+
750
Note:
The above speeds can vary with different
types of wood and the skill of the operator.
Sanding:
Use the fastest speed possible without
burning the wood.
Polishing and Finishing:
Typically, polishing and
finishing can be done at faster speeds than turning.
Figure 11
Tail Stock
(24)
Lock
Screw (19)
Tool Rest
Holder (20)
Figure 12
Lock
Screw (19)
Tool Rest
(21)
Tool Rest
Lock Knob
(23)
