Page 14
SKU 67690
For technical questions, please call 1-800-444-3353.
3. To adjust Tool Rest (21), loosen Tool
Rest Lock Knob (23) and swivel
Tool Rest as needed. The Tool Rest
should be 1/8” above the center-line
of the workpiece. Then tighten Tool
Rest Lock Knob.
To Remove The Tail Center (27):
1. Loosen the Lock Screw (19) below
the Tail Stock approximately half a
turn counterclockwise. See Figure
13, below.
2. Rotate the Hand Wheel (29)
counterclockwise until the Tail Screw
(25) bottoms out, causing the Tail
Center (27) to be forced off of the Tail
Screw.
3.
WARNING!
The Tail Stock must
always be locked in place while
the Lathe is in use. The workpiece
can be thrown from the Lathe if
this step is not followed. The Tail
Screw should not protrude from the
Tail Stock more than 2” or the Tail
Axis will not be supported enough.
Failure to follow these warnings may
result in personal injury.
The Power Switch Safety Switch:
1. The Lathe features a yellow Safety
Switch on the Power Switch (14) to
prevent unauthorized use. See Figure
14, below. To turn the Lathe on, first
plug the Power Cord (15) into the
nearest 120 volt, grounded, electrical
outlet.
2. Insert the Safety Switch into the Power
Switch. Move the Power Switch to the
“ON”
position. To turn the Lathe off,
move the Power Switch to the
“OFF”
position.
3. To lock the Power Switch in the
“OFF”
position, remove the Safety Switch and
store it in a safe location away from
children and unauthorized personnel.
Figure 13
Safety
Switch
Power
Switch (14)
Figure 14
Tail Stock
(24)
Lock
Screw (19)
Hand Wheel (29)
Tail
Screw
(25)
Tail
Center
(27)
Tail Nut
(26)
