Page 17
SKU 67690
For technical questions, please call 1-800-444-3353.
increase safety and gain adequate
working room.
Other Wood Turning Rules to Follow:
1. Check where the speed is set before
turning on the Lathe. Speed is a
critical parameter in turning.
2. Don’t let the tool touch the wood until
after it is on the Tool Rest. If you do,
the tool will slap down on the Tool
Rest, resulting in possible injury to
you or damage to the work piece.
3. Rub the bevel of cutting tools. The
bevel is the reference for cutting
tools.
4. The only part of the tool that touches
the work piece is that which is in
contact with the Tool Rest.
5. Always cut down grain.
6. Spin work to ensure clearance with
Tool Rest.
7. Keep forward hand in contact with the
Tool Rest.
8. Keep tools sharp.
9. Stop the Lathe to change Tool Rest
positions.
10. Scrapers must be flat on the Tool
Rest with the handle higher than the
contact point with the work.
11. Do not sand with the Tool Rest in
place. Get it well out of the way
before operation.
12. Stop and check when anything feels
or sounds wrong.
Attaching / Removing Sanding Paper
(35):
1. Disconnect Lathe from power source.
2. To attach or remove Sanding Paper
from Sanding Disc, first remove the
Work Table assembly. To do so,
loosen Set Screw (55) and pull the
Table Bracket (39) away from the
housing.
3. Peel about 3” of the paper backing
and fold it back on the sanding paper.
Position the opposite end of the
Sanding Paper against the edge of
the Disc (keeping the glued section
away from the Sanding Disc). Lower
the peeled face of the sanding paper
against the Disc and press lightly
to adhere. Tilt the top of the paper
away, gently peel off the remaining
backing paper, and press the sanding
paper against the disc. Position a flat
board against the sanding paper and
apply pressure (see sanding paper
manufacturers recommendations) to
properly adhere.
4. To remove a damaged or worn
sanding paper, simply peel the
adhered paper. Soaking the Sanding
Paper with rubbing alcohol may
speed up the peeling application.
Prior to attaching a new sand paper,
always make sure that the surface of
the Sanding Disc is clean and free
of glue residue. If required, wipe with
paint thinner. Use in a well-ventilated
area and avoid inhaling the fumes.
5. Reattach the Work Table, following
step 1 above in reverse order.
