Page 10
SKU 67690
For technical questions, please call 1-800-444-3353.
2. Once Drive Center is removed,
thread Faceplate onto Main Spindle
and hand-tighten only. See Figure 2.
3. To attach Sanding Disc (34), align
flat Set Screw (55) at the back of
Sanding Disc with the flat face of
Spindle and then slide Disc over
Spindle. Then use Hex Wrench (71)
to tighten Set Screw. See Figure 3,
below.
4. To install Work Table (36), slide Table
Bracket (39) into slot on the belt
housing. Then use Set Screw and
Hex Wrench to fasten the Bracket.
See Figure 4.
5. Use the Lock Screw (38) to secure
Table Angle Gauge (37) to the Work
Table. See Figure 4.
6. Once the Work Table is secured, set
the Miter Gauge (43) onto the Work
Table by sliding the Miter Gauge
Slider (46) into the groove on the
Work Table. See Figure 5, below.
Figure 2
Faceplate
(9)
Figure 4
Hex
Wrench
(71)
Table
Bracket
(39)
Work
Table
(36)
Lock
Screw
(38)
Figure 5
Work
Table
(36)
Miter
Gauge
(43)
Miter
Gauge
Slider
(46)
Figure 3
Sanding
Disc
(34)
Hex
Wrench
(71)
Set
Screw
(55)
Set Screw
(55)
Spindle (2)
