Central Machinery 43353, Руководство по сборке и эксплуатации

Страница: 6 / 11

Page 6 SKU 43353
Use a protractor or other measuring tool to ensure accuracy.
5. Rotate the sheet metal 90 degrees counterclockwise.
Allow the completed side to extend just beyond the Dies.
6. Bend the sheet metal. Repeat step 5 for the 3rd side.
7. Rotate to the final side and insert the sheet metal lip between the Dies.
The formed sides will be on the outside of the Dies.
8. Before bending the 4th side, tap one corner nearer the middle of the machine.
This will allow the sides to clear the upper Die (12) when raised.
Rolling
1. Lift the front Cover (33) and flip backward, out of the way.
2. Drop the Rear Roll Bar (24) by loosening the Adjustment Knob (25b).
3. Insert only the leading edge of the sheet metal between the Upper Roll Bar (32) and
the Lower Roll Bar (31), tighten the Adjustment Keys (27) until the Roll Bars are just
snug against the sheet metal.
4. Advance the Adjustable Bolt (25b) to the desired tightness for the roll.
The more the Adjustable Bolt (25b) is advanced, the tighter the roll.
5. Turn the Handle Arm (18) until the desired roll is achieved.
The sheet metal should feed itself through the rollers as the Handle Arm (18) is turned.
Wire Rolling
1. Select the proper size groove in the Upper Roll Bar (32) depending upon the gauge of
the wire being rolled.
2. Follow steps 2 through 5 (above), under Rolling.
Adjustments
While making adjustments, it may be necessary to refer to the Assembly Drawing at the end
of this manual
Handle Removal and Adjustment
The Handle Arm (18) may be adjusted or removed by removing one of the Handle Knob
Assemblies (26a, 26b, 61) and loosening the Knob (59) that holds the Handle Arm (18) in
place. It may then be slid out of the handle socket.
Bending Die Adjustment and Removal
The Upper Die (12) is segmented and can be used for varying sizes of box and pan forming.
When forming a smaller box or pan, choose the desired size Upper Die (12) finger, center it
and remove the others.