Page 9
SKU 32966
for technical questions, please call 1-800-444-3353.
Use the Screws (16A), Washers (18A), and Nuts (19A) to secure the Front Side Plate
(15A) and Rear Side Plate (34A) to the Side Angle Plates (24A) and Reinforcing
Plates (3A).
(See Assy. Diagram.)
Locate the Crossbeam Plate (17A). Connect the Crossbeam Plate to the
underside
of the two Side Link Plates (24A) by inserting four Screws (16A) from the top two
holes of each Side Angle Plate downward through the two holes at each end of the
Crossbeam Plate. Then secure the Crossbeam Plate to the two Side Link Plates,
using four Washers (18A) and four Nuts (19A).
(See Assy. Diagram.)
Locate the Tapping Plate (26A), Left Tapping Fender (29A), Right Tapping Fender
(25A), Left Protect Plate (28A), and Right Protect Plate (8A).
(See Assy. Diagram.)
Attach the Right Tapping Fender (25A), with its wide end at the top, to the right side
of the Tapping Plate (26A) using two Screws (16A), two Washers (18A), and two
Nuts (19A).
NOTe:
The flanges on the Tapping Plate should be facing outward as
shown in the Asembly Diagram.
(See Assy. Diagram.)
Attach the Left Tapping Fender (29A), with its wide end at the top, to the left side of
the Tapping Plate (26A) using two Screws (16A), two Washers (18A), and two Nuts
(19A).
(See Assy. Diagram.)
Attach the Right Protect Plate (8A) to the Right Tapping Fender (25A) and Left Tap-
ping Fender (29A) using the Screws (16A), Washers (18A), and Nuts (19A).
(See Assy. Diagam.)
Connect the bottom of the Upright Plate (4A) to the Crossbeam Plate (17A) using two
Screws (16A), two Washers (18A), and two Nuts (19A).
(See Assy. Diagram.)
4.
5.
6.
7.
8.
9.
10.
fIGuRe D
MOTOR (33A)
upRIGHT plATe (4A)
ScReW (5A)
WASHeR (7A)
lOck WASHeR (30A)
NuT (6A)
Brought To You By Augusta Flint
