Page 15
SKU 32966
for technical questions, please call 1-800-444-3353.
Turn the Screw (48) in or out against the Stop Block (44) until the Fence Body
(4) is at 90 degrees to the Front Table (2) and Rear Table (3). Then, retighten
the Screw.
Follow this same procedure to check the positive stops at 45 degrees, left and
right.
(See figure H and Assy. Diagram.)
GeNeRAl cuTTING pROceDuReS
THe pOWeR SWITcH AND OVeRlOAD pROTecTOR
The “ON”/”OFF” Power Switch (14A) buttons are located on the front of the Rab-
beting Jointer. Simply press the “ON” button to turn on the machine and press the
“OFF” button to turn off the machine. Always allow the Cutter Head Assembly (8)
to spin at full speed before feeding a workpiece into it.
The Rabbeting Jointer features a built-in overload protection system that, in the event
the Motor (33A) overheats, will automatically shut off the machine. In the event of
b.
c.
1.
2.
WOODSTOck
fRONT TABle (2)
ReAR TABle (3)
cuTTeR HeAD ASSy. (8)
fIGuRe I
an automatic shutdown, turn the Power Switch to its “OFF” position. Wait several
minutes for the Motor to cool down. Then restart the machine.
plAceMeNT Of HANDS DuRING THe cuTTING pROceSS
cAuTION! Never pass hands directly over the cutter Head Assembly (8)
when cutting a workpiece.
At the start of a cut, the left hand holds the workpiece firmly against the Front Table
(2) and the Fence Body (4), while the right hand pushes the workpiece toward the
Cutter Head Assembly (8).
After the cut is underway, the new surface of the workpiece rests firmly on the Rear
Table (3). The right hand pushes the workpiece forward, but before the left hand
1.
2.
3.
MOVe WORkpIece IN THIS DIRecTION.
Brought To You By Augusta Flint
