Page 13
SKU 32966
for technical questions, please call 1-800-444-3353.
TO ADJuST THe cuTTeR HeAD ASSeMBly
WARNING! Always check the knive (16) settings and tightness before
each use of the Rabbeting Jointer.
The three Knives (16) on the Cutter Head Assembly (8) must always be kept sharp
for proper performance. Should the Knives need to be sharpened or replaced, fol-
low the Steps below:
Place a Knife (16) in its groove in the Cutter Head Assembly (8) so that the rear
edge of the bevel is 1/16” from the surface of the Cutter Head.
(See Assy. Diagram.)
Slide the Knife Stock Bar (14) into place and lightly tighten the four Knife Set
Screws (17).
(See Assy. Diagram.)
Place a “Knife Setting Bar” (made from a piece of scrap wood, approximately
12” long) on the Rear Table (3).
(See figure G and Assy. Diagram.)
Open the panel on the Left Protect Plate (28A).
(See Assy. Diagram.)
Use the Pulley V-Belt (12) to rotate the Cutter Head Assembly (8)
backward
.
cAuTION! Do not attempt to turn the cutter Head Assembly by placing
your hand on it. (See Assy. Diagram.)
While slowly rotating the Cutter Head Assembly (8) backward, adjust the Knife
(16) until it just touches the scrap piece of wood.
(See figure G and Assy. Diagram.)
Using the scrap piece of wood as a guide, check to make sure the Knife (16) at
each end is parallel to the top of the Rear Table (3).
(See figure G and Assy. Diagram.)
1.
2.
a.
b.
c.
d.
e.
f.
g.
ScRAp WOOD (“kNIfe SeTTING BAR”)
ReAR TABle (3)
kNIfe (16)
cuTTeR HeAD ASSy. (8)
fIGuRe G
Brought To You By Augusta Flint
