Central Boiler Fire Star, Руководство по эксплуатации

Страница: 13 / 18

13
FIRESTAR COMBUSTION CONTROLLER - VERSION 6.7 • OPERATION MANUAL
Menu # Setting DEFAULT Min. Max.
8 WI-FI ENABLED
After configuration has been performed, use this menu item to disable (or
enable) the wi-fi feature without losing your network settings . During a
new installation, proceed directly to menu item #9 to enable wi-fi for the
first time .
0 0 1
9
WI-FI ENABLED CONFIGURATION
Setting this to 1 will enable wi-fi and turn on the configuration network .
This will erase any current wi-fi settings . When the Connected light turns
blue, find the Firestar_network on your smartphone; then visit http://
www .wifiset .net to configure your network settings .
0 0 1
10 WI-FI WIRELESS N SUPPORT ENABLED
When set to 1, the FireStar will be able to use the 5gz frequency (where
available) . May significantly lower wi-fi range . 0 0 1
11
SOFTWARE UPDATE OPTION
The FireStar controller has the ability to download and install software
updates through the internet . Take note of the current software version
number before updating by quickly pressing the Power button once .
If required, set this variable to 1 to initiate a software update . A wi-fi
connection is required (the connected light should be green) . During a
software update, furnace operation will stop and the display will flash
special characters to indicate the update process . The entire process should
take about 5 minutes . Do not disconnect power during this process . In
the event of a update failure, BF-4 will be displayed . If an update failure
occurs, turn the FireStar off and back on to restore operation to the
original software version . Repeated update failures may mean that all
available updates are already installed . When an update has completed,
you may need to power the furnace back on . Be sure to take note of the
new software version number and acquire the appropriate documentation
for the new version .
0 0 1
12 WI-FI NETWORK SSID (READ ONLY)
Displays the current wi-fi network being used by the FireStar . To use a
different network, reconfigure the FireStar using menu item #9 . - - -
13 WI-FI SERIAL NUMBER (READ ONLY)
Displays the serial number of the furnace used during wi-fi
communication . Typically begins with a letter . An incorrectly entered
serial number can be adjusted by visiting http://myfirestar .com/find on a
smartphone that is attached to the same wi-fi network as the FireStar .
- - -
14
WI-FI IP ADDRESS (READ ONLY)
Displays the local IP address assigned to your FireStar by your wi-fi router .
The FireStar must be successfully connected to wi-fi first . This is a read
only item--if a static IP is desired, you must set a reservation on your
router by MAC address .
- - -