Central Boiler Fire Star, Руководство по эксплуатации

Страница: 11 / 18

11
FIRESTAR COMBUSTION CONTROLLER - VERSION 6.7 • OPERATION MANUAL
Setup Mode and Adjusting FireStar Settings
One of the most powerful features of the FireStar Combustion Controller is
that it provides you with numerous settings you can customize and fine-tune
to the types of wood you are burning and to your heat load. This can help you
obtain the cleanest and most efficient operation of your outdoor furnace that is
possible.
To Enter Setup Mode
Press and hold the Menu button for 10 seconds until the LED display
changes from the water temperature to 1. The controller is now in Setup Mode.
If no buttons are selected before ten seconds, the controller will automatically
exit Setup Mode.
Changing Control Variables
While in Setup Mode, refer to the Variables Chart and select the control
variable you want to change using the or buttons. Press the button
to select the variable by menu number. Use the or buttons to adjust the
variable to the desired setting. Press the Menu button to save the setting
and return to Setup Mode.
To Exit Setup Mode
Wait 10 seconds (without pressing any buttons) and the controller will
automatically exit Setup Mode.
To reset controller to default settings:
1. Press the Power button to turn off the controller; then, while pressing
and holding the Ignition Air button, press the Power button to
turn on the controller. The LED display will momentarily indicate
(clear settings).
2. Press the or button to select the furnace model; then press the Menu
button to save.
3. Continue to press the button as shown on the display to perform each
diagnostic test. The last message will display PRESS UP TO EXIT. Press
the button and the controller will run using factory default settings.
4. Verify that the furnace is operating by making sure that the water
temperature and the Reaction Chamber temperature are alternating on the
screen.
5. If the furnace was connected to the internet prior to resetting to default
settings, it will be necessary to enable wi-fi again by setting Menu Item #8
to a value of 1 (see Setup Mode and Adjusting FireStar Settings).