CentoLight ZEPHIRO SNOW 600, Руководство пользователя

Страница: 10 / 24

10 10
Zephiro Snow 600 User Manual
Eng
spilling over to cause short circuits.
y
The snow machine should work under professional operator’s supervision,
please do not add flammable liquids or gas into the snow fluid tank.
y
When you don’t use the machine for long time or after use, please disconnect
power or unplug the power cable. After using, please wipe out the liquid in the
tank, as it would avoid the housing to be corroded.
y
All snow machines will have condensation or moisture around the Output De-
flector.
y
All snow machines have heating-cooling cycles. When internal temperature
drops to minimum, the pump automatically turns on and begins heating. Once
heating is complete, the machine starts to spray snow again.
y
In the case of a serious operating problem, stop using the unit immediately.
Never try to repair the unit by yourself. Repairs carried out by unskilled people
can lead to damage or malfunction. Please contact the nearest authorized tech-
nical assistance center Always use the same type of spare parts.
y
Never connect the device to a dimmer pack.
y
Make sure the power cable in never crimped or damaged and never disconnect
it by pulling or tugging on the cable.
6.1. Routine Maintenance And Common Faults
ATTENTION: Periodically clean your machine to reduce replacement parts and
repair expenses.
y
Poor snow liquid can cause blockage. It is recommended to use high quality
snow liquid.
y
Wash the pipe in the tank and its filter head.
y
Pour out any liquid inside, and replace with the cleaning liquid (80% distilled
water and 20% white vinegar), turn on power, keep it operating till the cleaning
liquid runs out.
y
If the now turns less, and the pump makes noise, switch off the unit immediate-
ly and check fluid level, controller interface and power plug. If all of these are
normal, please connect power again. If problems still continue, please contact
the supplier.
y
When you shut down the machine, it is recommended that you remove any
remaining fluid inside. Especially when the machine will not be used for a long
time. It is recommended that you open the tank, remove the fluid hose and
place it next to the tank in open air.
y
After use, let the snow machine cool down before transporting it by the handle.
Let the machine cool down for at least 20 minutes and only transport it when
the housing of the machine reaches a temperature that is comfortable enough
to handle. Transporting the machine while it is still hot may cause injuries and