6
ENGLISH
– Fully insert the locking pin (17) into the head.
The die set is polarised and can only be installed one way to ensure the correct insertion of
the locking pin (17).
– To remove the die set from the head: open the locking lever (18), completely remove the locking
pin (17) and slide the die set out of the tool.
2.7) Battery status
The battery is equipped with LED indicators that indicate the remaining battery life at any time by
pressing the adjacent button (P).
4 LEDs illuminated: Fully charged
2 LEDs illuminated: 50 % capacity
1 LED fl ashing: Minimum charge, replace the battery
W
HEN
THE
BATTERY
VOLTAGE
HAS
DROPPED
BELOW
A
MINI
-
MUM
SAFETY
THRESHOLD
,
THE
TOOL
WILL
NOT
START
,
AND
IT
IS
NECESSARY
TO
RECHARGE
OR
REPLACE
THE
BATTERY
.
The approximate time to fully recharge a battery is about 40 minutes.
2.8) Insertion/replacement of battery
To replace the battery, remove it by pressing the release button (15) (Ref. to Fig. 6 page 26), then
insert the new battery, sliding it into the guides until it locks.
3. WARNING
T
HE
TOOL
IS
UNSUITABLE
FOR
CONTINUOUS
USE
AND
SHOULD
BE
ALLOWED
TO
COOL
DOWN
FOLLOWING
UNINTERRUPTED
,
SUCCESSIVE
CUTTING
OPERATIONS
;
FOR
INSTANCE
,
HAVING
EXHAUSTED
A
FULLY
CHARGED
BATTERY
IN
ONE
SESSION
,
DELAY
BATTERY
REPLACEMENT
FOR
A
FEW
MINUTES
.
O
BSERVE
RECOMMENDED
REST
PERIODS
ALSO
WHEN
USING
AN
EXTERNAL
POWER
SUPPLY
.
D
O
NOT
USE
THIS
TOOL
ON
LIVE
CABLES
.
P
ROTECT
THE
TOOL
FROM
RAIN
AND
MOISTURE
. W
ATER
WILL
DAMAGE
THE
TOOL
AND
BATTERY
.
E
LECTRO
-
HYDRAULIC
TOOLS
SHOULD
NOT
BE
OPERATED
IN
POURING
RAIN
OR
UNDER
WATER
.
3.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.
4. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance of the tool:
2
P
W
HEN
THE
BATTERY
VOLTAGE
HAS
DROPPED
BELOW
A
MINI
-
MUM
SAFETY
THRESHOLD
,
THE
TOOL
WILL
NOT
START
,
AND
IT
IS
NECESSARY
TO
RECHARGE
OR
REPLACE
THE
BATTERY
.
