CEMB N330, Руководство пользователя

Страница: 81 / 160

Rotors balancing mode 11 - 11

Correction runs
After performing the test run (see 11.8 - Test run: known mass in known position ),
press (NEXT) to go to the unbalance correction screen.
single plane balancing dual plane balancing
correction weight on plane “P2”
The instrument shows the value and the position where the correction weight
required to balance the impeller must be positioned.
Caution:
If in NEW PROJECT SETUP screen (see 11.2 - New project – BALANCING
SETUP ) the ROTOR SETTINGS function has been enabled, the screen shows
whether the residual unbalance amplitude is within tolerance or not with
respect to
ISO 21940-11 .
Press (HOME) to go back to the instrument home page; press (MENU) to go to
the menu of the function (see 11.13 – MENU function ).
Note:
From this point, going back to the instrument home page and accessing again
to the rotors balancing function, will be available the item "Use current
project" (see
11.6 – Use current project ).
Note:
In the case of dual plane balancing, key allows to switch from the screen
of the correction required in plane P1 to plane P2 and vice versa.