CEMB N330, Руководство пользователя

Страница: 77 / 160

Rotors balancing mode 11 - 7
Press to start vibration measurement.
During the measurement, a bar is displayed that shows the quality of the
measurement in real time.
single plane balancing dual plane balancing
The higher is the level of the bar, the better will be the quality of the measurement
(which is averaged over time). After reaching the required level, stop the
measurement again by pressing .
single plane balancing dual plane balancing
Note:
Unstable signals produce measures whose quality fails to reach acceptable
levels.
In these conditions it is advisable to stop the measurement with pressing ,
and consequently repeat the procedure by pressing again .
Note:
If the quality of the measurement has been altered by a specific event (for
example a collision), the time needed to make it rise could be too long; to
speed it up, it is advisable to stop and restart the measurement by pressing
the key .
Caution:
The average speed value is very important because the calibration procedure
can be considered to be well executed only if between each step this speed
does not show differences greater than 5%. The control of this condition is
left to the operator.