CEFLA NewTom 5G Series, Руководство по обслуживанию, Страница: 12 / 23

NewTom 5G series – Patient Table Service Procedures 3-4
Search for the maximun limit switch of the pantograph.
It is part of the PANT FC BOTH procedure.

PANT. FC BOTH
(ATTENTION: risk of collision between mechanical parts!)
Pantograph potentiometer calibration: to be run only after replacement of pantograph
motor/potentiometer.
This procedure includes both the PANT FC BOTTOM and PANT FC TOP processes.

SET 1177 PANTOGRAPH:
This procedure set the firmware installed on the Hanning 97661177 pantograph board.
To set the board:
1) Disconnect C6 connector (5G - patient table).
2) Disconnect X207 connector located on 97661178 board.
3) Disconnect J8 connector located on 97660897 board.
4) Select “SET 1177 PANTOGRAPH” command from the service menu and press OK to confirm.
5) Turn off the machine.
6) Connect C6 connector (5G - patient table), J8 connector and X207 connector.
7) Turn on the machine and perform the “Pantograph potentiometer calibration” by select PANT. FC
BOTH command from Service menu.
NOTE: It is possible to set only “not setted” boards.

SET 1178 TABLE:
This procedure set the firmware installed on the Hanning 97661178 table board (located on the upper
structure).
To set the board:
1) Disconnect C6 connector (5G - patient table).
2) Disconnect X207 connector located on 97661177 board.
3) Disconnect J8 connector located on 97660897 board.
4) Select “SET 1178 TABLE” command from the service menu and press OK to confirm.
5) Turn off the machine.
6) Connect C6 connector (5G - patient table), J8 connector and X207 connector.
7) Turn on the machine and perform the “Stretcher potentiometer calibration” by select TABLE POT.
CALIB. command from Service menu.
NOTE: It is possible to set only “not setted” boards.