31
30
1.
Suction base release button
2.
Vacuuming tube release button
3.
Dust tank release button
4.
High-efficiency filter
5.
Power push button
6.
Power button
7.
Power supply
8.
Battery
9.
Power adapter
10. Vacuuming Flex tube
11. Suction base
12. Union elbow
13. Extensible tube
14. Long brush
15. Narrow brush for furniture and corners
16. Wide brush for furniture and corners
17. Motorised upholstery brush
18. Wall bracket
19. Wall plugs
20. Screws
21. Dust tank
22. Jalisco brush
23. Silicone and bristles brush
24. Adhesive for wall bracket
25. Water tank for scrubbing
3. BEFORE USE
Take the product out of the box.
Check for any visible damage, if any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
4. PRODUCT ASSEMBLY
Vacuuming tube and suction base assembly
To install the suction base into the vacuuming tube, align both of them making sure the tab on
ENGLISH
2.
PARTS AND COMPONENTS
Fig. 1 (Рage 38)
ENGLISH
the suction base matches the guides on the tube, and introduce one into the other until they
are firmly fixed. To disassemble them, press the suction base release button and pull from
the vacuuming tube while you hold the suction base.
Fig. 2
(Рage 39)
Note: when assembling these 2 parts, make sure the handle and the brush are facing the
same direction.
Use the Flex tube to reach and clean the most difficult areas and dirt. To bend the tube, press
the Flex button.
Battery and handheld
vacuum cleaner assembly
Introduce the battery in the slot located in the handheld vacuum cleaner. Once it is
introduced, move it slightly to ensure it is properly assembled in place.
Fig. 3
(Рage 39)
Following the below illustration, keep the vacuuming tube vertically, align the tab on the
vacuuming tube with the guides in the handheld vacuum cleaner and introduce the tube.
Dust tank and handheld
vacuum cleaner
To assemble the dust tank to the handheld vacuum cleaner, first separate the handheld
vacuum cleaner from the vacuuming tube.
Then, press the vacuuming tube release button with one hand and, holding from the handle
with the other one, turn the dust tank anticlockwise to the unlock position indicated on
the
dust tank edge.
To disassemble the dust tank, turn it clockwise until it reaches the unlock position.
Fig. 4
(Рage 39)
Suction base, vacuuming tube and handheld vacuum cleaner installation
To complete the full installation of the device, hold the vacuuming tube with the suction base
assembled upright and introduce the tube in the handheld vacuum cleaner as shown on the
illustration.
Fig. 5
(Рage 39)
5.
OPERATION
Handheld vacuum cleaner
Once the handheld vacuum cleaner has been disassembled
from the vacuuming:
Press the On/off button to turn the device on.
Press the power push button
to select the desired power level.
It will automatically operate in Eco mode. The power level can be adjusted at any moment by
pressing this button.
Press once to switch to Daily mode.
Press again to operate it at Turbo mode.
CONGA ROCKSTAR 700 ULTIMATE ERGOWET
CONGA ROCKSTAR 700 ULTIMATE ERGOWET
