cecotec 05419, Инструкция по эксплуатации

Страница: 31 / 71

ENGLISH
32
if necessary until it finishes it. Once it has completed cleaning, the robot will operate in
Random mode until it runs out of battery.
2. Edge mode: the display will show MODE 1, the robot will clean along the edges and will
return to the charging base through its smart technology once it has finished. If there is
no charging base, the robot will return to the starting point.
3. Area mode: the display will show MODE 2 and the robot will clean a 2*2 m area.
4. Random mode: the display will show MODE 3, will start cleaning randomly and then will
return to the charging base with its smart technology once it runs out of battery. The
robot will not create any map under this mode.
5. Twice mode: the display will show MODE 4, the robot will carry out a whole cleaning cycle
following the next pattern: Gyro mode, Edge mode, Gyro mode and Edge mode again.
When the cycle is completed, it will return to the charging base with its smart technology.
6. Scrubbing mode: Press the button to enter the water-intensity mode and select
the desired intensity and select between 1, 2 or 3 (see WATER INTENSITY/TIME SETTINGS
section).
The display will show MODE 6. With this mode, the robot will carry out a cleaning
cycle in Gyro mode and in Edge mode, moving forward 2 metres and then backwards 1
metre consecutively, simulating a real scrubbing movement. It will return to the charging
base if necessary to finish cleaning, and finally will return to the charging base when it
runs out of battery. You can select the desired water intensity level: high, medium or low.
• Do not use the mop outdoors.
• Remove the carpets before operating the robot under this mode.
• During operation, control the water level on the Wet&dry tank. If it empties, fill it up
again before continuing scrubbing.
• Take the Wet&dry tank and the mop out before charging the robot.
Note
: in order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
7. Gyro mode:
When this mode is activated, the robot
willcarry out a whole cleaning cycle in Gyro mode and then
in Edge mode. The display will show MODE 5. Once it has
finished, it will automatically return to the charging base. If it
has not started the cleaning cycle form the charging base, it
will return to the starting point.
Note: If the room being cleaned is smaller than 10 m2, the robot will carry out the same cycle
twice.
8. Manual mode
• Use the direction buttons to take the robot to the specific points where you want it
to clean.
9. Back home mode
• This mode can be selected at any point of any cleaning cycle. Once it is activated,