Cecilware GB5MF-IT, Руководство по эксплуатации, Страница: 21 / 33

15
Cleaning the Hoppers (See Illustration E)
1. Open the cabinet door and raise the top cabinet lid.
2. Take the hopper out of the cabinet.
3. Pull off the elbow chute and remove the hopper cover.
4. Unscrew the auger gear CW while holding steady the auger inside the hopper. Take out the auger, agitator wheel, and spring.
5. Rinse each item thoroughly.
6. Let dry all items and reassemble.
Filling the Hoppers
1. Open the cabinet door, raise the top cabinet lid.
2. Fill each hopper with the correct product.
Note: Hoppers can also be removed for filling.
3. Reposition hoppers in the hopper compartment, making sure the hoppers are properly seated.
Flushing the Whipper Chamber
1. Open the cabinet door and turn the RINSE switch to ON.
2. Place a container under each dispense nozzle and push the dispense switches.
Note: On manual dispense machines, push and hold the dispense buttons for 10 seconds.
3. Open the cabinet door and turn the Rinse switch back to OFF.
4. Wash and let dry the splash panel.
5. Remove the drip tray, wash and let dry thoroughly.
Removing and Cleaning the Whipper Chambers (See Illustration E)
1. Remove the dispense cap by pulling it forward and at the same time twisting it clockwise.
2. Grab and pull the mixing bowl out of the mixing bowl socket.
3. Grab and twist the whipping chamber clockwise and pull it off the mounting plate.
4. Pull the Whipper blade off the motor shaft. Notice the flat keyway on the shaft and the
matching keyway inside the Whipper blade shaft.
It is important that these two keyways are lined up when re-assembling the components.
5. Twist the mounting plate clockwise and pull it off the motor shaft.
6. Slip off the o-ring from the Whipper chamber mounting plate and clean o-ring and o-ring seat.
Removing and Cleaning the Mixing Chambers (See Illustration E)
1. Remove the dispense cap.
2. Pull the mixing bowl out of the mixing bowl socket.
3. Take out the extension tubes.
4. Rinse them thoroughly
TROUBLE SHOOTING GUIDE
WARNING: To reduce the risk of electrical shock unplug the dispenser power cord before repairing or replacing any internal
components of the unit.. Before any attempt to replace a component be sure to check all electrical connections for proper
contact
PROBLEM PROBABLE CAUSE REMEDY
1. Light Display not
lit. No power.
a) Dispensing unit unplugged
b) No power from Main Board or from Power
Switch.
c) Defective Bulb
d) Loose Bulb in socket. a) Reconnect dispensing unit
b) Check for loose wire to Main Board or to Power Switch.
c) Replace Bulb.
d) Make sure bulb is seated properly in socket.
2. No water when
Rinse Switch is
ON.
a) Water supply OFF.
b) Clogged inlet screen (Water Inlet Valve).
c) Inoperative Water Inlet Valve.
d) Loose electrical connection.
a) Turn water ON.
b) Disconnect water line and clean inlet screen.
c) Check connection, if needed replace Valve.
d) Check all electrical connections.