background image

GB Series

Cecilware

®

2

For safe and proper operation, the appliance must be placed in a stable, vertical position. 

To reduce risk of serious burns or scalding do not place hand or other body parts under dispenser or container
while product is brewing.

Always unplug unit from power supply before servicing.

Surfaces are hot and can cause burns.

CAUTION

To reduce risk of electrical shock, do not remove or open cover. No user-serviceable parts inside. Repair should
be done by authorized service personnel only.

The appliance is not intended for outdoor use.

Do not clean with a water jet or use in an area where a water jet may be used.

Cleaning and maintenance shall be made only by properly trained persons with supervision.

This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Do not alter or deform the power cord or plug in any way! Altering or deforming the plug may cause electrical
shock, damage unit and will void warranty.

To reduce risk of explosion or fire, do not use near combustibles.

WARNING

Safety Information

2

Cecilware

®

Water Boilers

Important Safety Information

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.

For your safety and the safety of others, read all warnings and the operator manual before installing or using
the product. 

DANGER:

This term warns the user of imminent hazard that will result in serious injury or death.

WARNING:

This term refers to a potential hazard or unsafe practice, which could result in serious injury or death.

CAUTION:

This term refers to a potential hazard or unsafe practice, which could result in minor or moderate

injury.

NOTICE:

This term refers to information that needs special attention or must be fully understood. 

Use only on a circuit that is properly protected and capable of the rated load.

Electronically ground the chassis.

Follow national and local electrical codes.

Do not use extension cord. 

This equipment must be installed in compliance with applicable Federal, State and/or Local plumbing codes
having jurisdiction. This product requires an approved backflow prevention water device, such as a double check
valve, that must be installed between the machine and the water supply. 

NOTICE

Содержание CME10E-N

















Отзывы: