Ceasa Kivu LCD UF HF 160, Инструкция по эксплуатации

Страница: 65 / 116

After installing the device and setting the relevant parameter, please
follow the
instructions as it's shown below
:
Fill the brine tank with the planned regeneration salt and water (
r
efer to the below
table ), making the brine
25%
saturated. Then start the device
.
This step is
o
nly
necesary when the device is being started for fist time.
Resin Tank
10 x 17 08 x 35 10 x 35
Water ( l )
10 15 23
Slowly o
pen the inlet valve to 1/4
of its
position
.
Avoid to open the valve too quickly
in order to not damage
the device and make the resin run off
. At this moment, slowly
open the network valve too.
After all air is out of pipeline, then open inlet valve completely. With a ph
meter, check the residual water hardness at the service stage. Make sure there
are no leaks in any installation part.
9. Start up Guide
Notice:
under normal
circumstances
,
the
user
doesn't need to do
any operation
,
except adding a certain amount of salt into the brine tank.
65 NASSER - CEASA