CHAPTER 3 - SOFTWARE CONFIGURATION
In following chapters, HD-300ZX is referring to all of the models, as the
software is identical. To configure your device, connect it to your TV or
any other display. Turn on the device and wait for it to boot. This could
take anywhere in between 10 and 40 seconds.
Note: The HD-300ZX will only look for new network devices during boot
up. If you change any of the network related settings, restart the device
to ensure the new setup takes effect.
1. After the system has booted, you will see the main screen on your
screen. To access your files, select the file type or use All Media and
press Enter.
2. Select the directory where your files are stored and press Enter to
browse for your files. HDD is the CF card, or computer and USB1/2 are
the drives attached to the USB ports. PC1 and PC2 are not supported
in this firmware.
3. To enter the setup menu, press the SETUP button on your remote
control.
Playback Modes
The HD-300ZX offers several different play modes. Some are
pre-defined, some are flexible, some are passive and some require
active user input.
Single: Plays according to one single playlist. If no playlist is found, it
stops at the library screen. Requires play.lst.
Repeat: Plays all compatible media files found in the root directory of
the internal drive and any attached USB drive. Repeats them
continuously. Requires media files on either internal drive or USB drive.
Standard: Files are accessed via remote control. There is no
automatic playback and the device behaves like a standard media
player. Requires media files on HDD, USB drive.
Manual: Plays 000 file at startup. Plays 001-999 AVI files after user input
via remote control and automatically returns to 000 file. Requires
000.avi or 000.jpg & 000.mp3 plus AVI video clips from 001-999.
Playlist
The HD-300ZX supports play back by playlist, to be played back
automatically at boot up or at a certain date and time. Play list can
be created using Quicksign 300 or CCM Enterprise. To enable this
function, select the Single playlist mode from the list and set the path
to your playlist.
1. Press SETUP on your remote control to enter the HD-300ZX’s setup
menu.
2. In the MISC1 category, select one of the playlist modes.
3. Set the Path to HDD.
