CDVI DGA, Руководство пользователя

Страница: 7 / 22

EN EN
DGA
Keypad DGA
7
cdvigroup.com
F. Reset master code
On stand-by operating mode,
short the wires yellow and white.
- One beep is emitted.
- Wait until the greed LED light is off.
- Seperate the two wires.
- The master code is restored to its default
value 1 2 3 4 5 in 5-digits code and 1 2 3 4
in 4-digits code.
G. Changing the code by a user
To authorize a user to modify its own
user code connect together the yellow
and blue wires.
1. Enter the old user code.
The relay is activated and a beep is emitted.
2. Enter the 2-digits sub master code
(default sub master code AB).
A beep is emitted to authorize modification.
3. Enter the new user code.
2 beeps are emitted to confirm
the new code.
4. Check the new user code to be sure
of the modification.
H. Setting a sub master code
The Sub Master code allows the user
to change its own code without entering
in programming mode. For security
reasons the code need to be changed
periodically. This feature makes it easier
and faster to change its code.
1. Enter the master code twice
( 1 2 3 4 5 default value master code).
2 beeps are emitted to confirm entry
in programming mode.
2. Press A7 to program a sub master
code for the user individual Pin
code modification.
(Press A8 for relay 2)
- One beep is emitted.
- Enter the new 2-digits sub master code.
- One beep is emitted to confirm
programming of the sub master code.
3. Press B to exit from
the programming mode.
2 beeps are emitted to confirm that the
keypad is in stand-by operating mode.
I. Audible Feedback
The audible signal is enabled in programming
mode and when the relay is energised
after a valid code. To enable the audible
feedback on a key press:
1. Enter the master code twice
( 1 2 3 4 5 default value master code).
2 beeps are emitted to confirm entry
in programming mode.
2. Press AA.
- One beep is emitted.
- Press 0 to disable the audible signal
during a keypress.
- Press 1 to enable the audible signal
during a keypress.
- One beep confirms the new setting.
3. Press B to exit from
the programming mode.
2 beeps are emitted to confirm that the
keypad is in stand-by operating mode.