CD-R King DP321, Руководство пользователя

Страница: 30 / 50

DP321 User's Manual
- 24 -
tractor paper position. Remove the printer cover, adjust the gap adjust lever according to the
paper type.
2. Make sure the tractor installed correctly (refer to chapter 1).
3. Load the tractor paper on the sprocket of the push tractor refering to “Printing in the push
tractor position”.
4. Turn on the printer, press
LOAD/EJECT
button to load the paper automaticly and the print
head is at the printing home position of the first page. Adjust the printing home position of page
layout if necessary. Hold
LF/FF
button, the printer feeds one page automatically.
5. Release the sprocket lock of the pull tractor and open the sprocket cover. Pull straight the
paper upwards, adjust the left and right sprockets unit they match the width of your paper. Then
clip the perforation of the paper into the sprockets of the pull tractor, lock the prockets at last.
The paper should be without twisted.
6. If the perforation of the paper is not match with the sprocket of the pull tractor when tightening
the paper lengthways, then you can do as follows:
1) Pull the paper select lever backward to the cut-sheet position.
2) Turn the paper feed knob until the paper is tightened lengthways.
3) Pull the paper select lever forward to the tractor paper position.
7. Reinstall the paper guide and printer cover again.
8. The printer begins printing automatically when receiving print commands.
3.1.3 Multi-part Forms
You can use the built-in tractor to print on carbonless multi-part forms of up to four parts (one
original plus three copies). Before you print on the forms, set the gap adjust lever as described in
the previous section. These tips will help you get good results:
1. Lift up the paper guide as figure 3-17 shown, or it may lead to paper jam when printing.
2. Never load multi-part forms joined by metal staples, tape, or continuous gluing.
3. Make sure the print contents are all within the printable area when printing multi-part forms, or
it may damage the print head. (See the printable area in Appendix)
Figure 3-16 Adjust the position of the pull tractor