CCS PD2 Series, Инструкция по эксплуатации

Страница: 8 / 16

- 8 -
4. Connectors
1. Output connectors: SM connectors (JST)
Pin
number
12V output 24V output 12V with fan 24V with fan
1 OUT + (12V) OUT + (24V) NC OUT + (24V)
2 OUT - NC OUT + (12V) NC
3 OUT - OUT - OUT -
4 Fan GND Fan GND
Connector SMP-02V-BC SMP-03V-BC SMP-04V-BC SMP-04V-BC
Channel 1 is output in parallel to the connector with power supply for 4-pin fans.
2. External control connectors: 15-pin D-sub plug with M2.6-mm screws
Each signal is pulled up to the 5V in the internal circuits with resistance.
Use a shielded cable of 3m or less for the control line.
Pin
number
Signal
1 Light intensity B0 (LSB)
2 Light intensity B1
3 Light intensity B2
4 Light intensity B3
5 Light intensity B4
6 Light intensity B5
7 Light intensity B6
8 Light intensity B7 (MSB)
9 External control (INT/EXT) B8
10 Light intensity data write (WR) B9
11 Channel 1 ON/OFF control (ON1) B10
12 Light intensity data write channel selection B11 (CH)
13 Channel 2 ON/OFF control B12 (ON2)
14 Overcurrent protection signal output B13 (OCP)
15 Signal GND
Optional cable: external control cable(cable length: 3m, with one side of the cable cut)
Note: Please read instruction guide using optional cable.