CCS PD2 Series, Инструкция по эксплуатации

Страница: 6 / 16

- 6 -
steps B7 [MSB] B6 B5 B4 B3 B2 B1 B0 [LSB]
Light
intensity(%)
Coarse Fine
1 H H H H H H H H 0.4 1 1
2 H H H H H H H L 0.8 1 2
3 H H H H H H L H 1.2 1 3
19 H H H L H H L H 7.6 2 3
254 L L L L L L H L 99.2 16 14
255 L L L L L L L H 99.6 16 15
256 L L L L L L L L 100.0 16 16
B10 (channel 1)
B12 (channel 2)
ON (lit) OFF (not lit) OFF (not lit)
1
0
10
µ
s * 10
µ
s
Lighting
3) Light intensity settings
Set the 8 bits from B0 to B7 as well as B9 to control light
intensity. Specify up to 256 light intensity steps using
bits B0 to B7 and send the write signal to write bit B9 to
write the light intensity data to the product. Keep the
write signal Low(L) for at least 300 µs to write the data,
and switch the signal back to High(H) after the minimum
write time has elapsed to stop writing data.
Note: Light intensity settings are enabled only as long
as the power supply remains ON and will be lost
when the power supply is turned OFF.
4) Lighting ON/OFF control
After you have selected the light intensity level, Use bit B10
(channel 1) and bit B12 (channel 2) for ON/OFF control.
*The delay is 10

s when the light intensity is 100%. If the light intensity is less than 100%,
there may be a delay of up to 30

s.