8
XXXX = Extension number to which call will land in Hotline f eat ure..
Dial #
0000 + 884 N # - To convert N Extension in normal mode.
Note
:
When all Extensions are converted to Hot Line then to get into the Programming mode, lif t Handset
– dial
#
0000
+ whatever Programming to be done.
Def ault: All extension is in Normal Mode.
.
Junction Access During Power Failure
.
When the system is switched OFF, the Junction lines get directly connect ed to f ollowing respective extensions.
Junction Number Extension Number to which it gets connected
01
601
02
602
.
Junction Access Codes / Change
.
Junction lines can be accessed in rotation by dialling 0.
To access a particular junction line:
#11 - To access 1
st
Junction Line
#12 - To access 2
nd
Junction Line
The junction access code can be changed
from 0 to 8. Refer heading ‘Junction Grouping’ for procedure.
.
Junction Access Control
.
Every Extension can be programmed to access Junction Line.
The access to each Extension can be dif f erent in Day mode and Night mode.
Procedure
:
Dial #
0000 + 70 J N X # (For Day Mode)
Dial #
0000 + 71 J N X # (For Night Mode)
Where J = Junction Number (1, 2)
N = Last Digit of Extension Number
X = 0 to Allow Junction access
1 to Disallow Junction access.
Dial #
0000 + 70 J X # (To allow/disallow all extensions to access Junction in Day Mode)
Dial #
0000 + 71 J X # (To allow/disallow all extensions to access Junction in Night Mode)
Def ault: All extensions are allowed to access Junction Line in both Day and Night mode.
.
Junction Dialing Controls
.
Junction dialing f acility can be controlled Extens ion wise as below
:
Dial #
0000 + 40 N L #
where, N= Last digit of Extension number.
L = 0 -
The Extension can dial only the numbers starting with digits defined in “Allowed Table”
1 - The Extension can dial all numbers.
2 - The Extension can dial all numbers except f or ISD numbers.
3 - The Extension can dial all numbers except f or STD numbers.
4 -
The Extension can dial all numbers except for the numbers starting with digits defined in “Denied
Table-
A”
5 - The Extension can dial all numbers except f or the
numbers starting with digits defined in “Denied
Table-
B”
6 - The Extension cannot dial out but can make internal calls.
To give all extensions the same L value:
Dial #
0000 + 40 L #
Note
:
In def ault: all extensions are in L = 1 mode.
.
Junction Call Hold + Transfer
.
To transf er a Junction line to another extension, FLASH and dial the Extension number while talking on the junction line.
Now there can be f ollowing 4 conditions:
1. When called extension lif ts, calling extension can converse and then keep the Handset down. The Junction call will
then get transf erred.
2.
Called extension lifts but doesn’t want to talk then he may keep the Handset down.
The call will come back to the transf erring extension.
3. The called extension is ringing but not lif ting the Handset. Keep the Handset down.
The call will ring on the called extension f or 25 secs and if not answered it will ring back on the transf erring extension.
Now if the Transf erring extension is busy, the Junction call will keep waiting f or the Transf erring extension to get f ree.
4. If the called Extension is engaged, the user will hear 2 tones. Now FLASH to get back to the Junction line. If FLASH is
not done within 10 secs, the Junction line will get connected. This is the def ault setti ng in the PBX.
