Cattron-Theimeg i-Key, Руководство по эксплуатации и техническому обслуживанию

Страница: 50 / 90

Section 4, Page 10

01/2001, CATTRON - THEIMEG
TM
Upper and Lower Main Body Housings (Figure 4-4, opposite).
CAUTION:
All circuit boards are sensitive to electrostatic discharge. Use an anti-static mat
and personal grounding strap (wrist) for all maintenance procedures involving
disassembly and assembly of PS controllers. Failure to comply with this caution
may result in equipment damage and will void our warranty.
Separate and remove the housings as follows:
a. Lay Controller face down on Anti-Static Mat and remove Battery Pack, Bottom Endcap
sub-assembly, and Top Endcap subassembly. Refer to Removal of Battery Pack,
Bottom Endcap sub-assembly , and Top Endcap subassembly , above.
b. Remove two rubber side grips (1) by sliding or pulling away from upper and lower main
body housings (2 and 3).
c. Completely separate upper and lower main body housings (2 and 3) by sliding them
apart.
Replace the housings as follows:
a. Apply a thin film of lubricant (Dow Corning MOLYKOTE 557 or equivalent) to upper
and lower main body housing (2 and 3) joints. Slide or snap the two housings together.
b. Install two rubber side grips (1) along their grooved upper and lower main body housing
(2 and 3) locations. To facilitate installation, a light application of window cleaning
spray or liquid (Windex or equivalent) may be applied to lubricate the inside channels of
each rubber grip.
c. Install Top Endcap subassembly, Bottom Endcap sub-assembly and Battery Pack. Refer
to Replacement of Top Endcap sub-assembly, Bottom Endcap sub-assembly and
Battery Pack , above.