Cateye Ergociser EC-5000 Service Manual
42
Fig.4
MS-3
Replacing the Pedal Chain
MS-3
Replacing the Pedal Chain
When replacing with brand-new chains, be sure to replace both of
the two chains.
REMOVAL
1. Detach the frame cover.
(See [D-1: Removing the Frame Covers].)
2. Using a plier, detach the snap of the chain joint which connects
the pedal chains and the spring. (Fig. 1)
3. While slightly pulling the spring, detach the plate at the snap
side of the chain joint.
4. While holding the pedal chain with a single hand, detach the
spring from the chain joint by pulling the spring.
5. Detach the chain joint that is left at the tip of the pedal chain,
and lower the pedal down to the lowest position.
6. Detach the snap of the chain joint which connects the linkstep
set and the step chain.
7. Pull off the chain joints in the right and left directions to remove
the pedal chain from the linkstep set.
General Figure
Link Step Set
Chain Joint
Chain Joint
Link Step Set
Pedal Chain
Spring
Shaft Set A
Pedal Chain
Pedal Chain
Chain Joint
Spring Pulley
Spring
Pedal Chain
Chain Joint
Fig.1
Fig.2
Fig.3
Fig.5
Fig.6